Xerox 123 User Guide

This section describes how to set up the network communication parameters of the 
machine.
At the machine, perform these steps.
NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IP 
network.

NOTE: CentreWare Internet Services can also be used to configure the machine. 
Refer to the CentreWare Internet Services chapter of the User Guide.

Initially, enable the IPP port.

Connect the machine to the network.

Display the [System Settings] screen.

NOTE: For more information about how to display the [System Settings] screen, refer 
to the Setups chapter of the User Guide.

Select [Network Settings].

Select [Port Settings].

Select [IPP], then [Change Settings].

Select [Port Status], then [Change Settings].

Select [Enabled], then [Save].

Next, establish TCP/IP.

Display the [System Settings] screen.

NOTE: For more information about how to display the [System Settings] screen, refer 
to the Setups chapter of the User Guide.

Select [Network Settings].

Select [Protocol Settings].

Select [TCP/IP – Get IP Address], then [Change Settings].

Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP], 
[DHCP/Autonet], or [Manual], and then select [Save].

NOTE: Use the DHCP server together with the Windows Internet Name Server 
(WINS) server.

If you selected [Manual] in step 5, then complete steps 6 to 11 to enter the [Protocol 
Settings]. Otherwise, complete step 14.

Select [TCP/IP – IP Address], then [Change Settings].