Xerox 123 User Guide

Use the keypad on the screen to enter the IP Address for the machine in the 
format “xxx.xxx.xxx.xxx”. Enter relevant values (0 to 255) into the highlighted field 
and select [Next]. The next 3 digits are highlighted. When you have finished 
entering all values, select [Save].

Select [TCP/IP – Subnet Mask], then [Change Settings].

Using the same method as in step 7, enter the Subnet Mask.

Select [TCP/IP – Gateway Address], then [Change Settings].

Using the same method as in step7, enter the Gateway Address.

NOTE: If you do not wish to set the Gateway Address, enter “0.0.0.0”.

Select [TCP/IP - IP Filter], then [Change Settings].

Select [On] to filter access to the machine.

NOTE: If you do not wish to use the IP filter feature, select [Off].

NOTE: Use CentreWare Internet Services to register the IP addresses which are not 
allowed to access the machine. Refer to the CentreWare Internet Services chapter of 
the User Guide.

When you have finished establishing TCP/IP, select [Close] from the [Protocol 
Settings] screen.

Install print drivers on each client workstation that will be sending print jobs to the 
machine, and map to the machine as a printer. Refer to the HTML document in 
CentreWare Utilities CD-ROM, for additional information.

To make sure that the machine has been installed on the network correctly a test print 
should be submitted from a client workstation. Perform the following steps.

Open a document on a client workstation.

Select the machine as the printer to which the selected document will be sent.

Print the document on the machine and verify that it prints correctly.

Make sure that the driver is installed on every workstation that will be sending jobs 
to the machine.

Repeat the test for all workstations that will be sending jobs to the machine.

The installation process is now complete.
If the test print fails, refer to the Problem Solving chapter for assistance.