Xerox x2 tech User Manual

The ColorgrafX X2 printer can print on a variety of media including 
paper, films, vinyl, and other special media.  The list of available 
media changes to meet customer requirements, so check with your 
sales representative to determine what media is currently available 
and in what roll sizes. 

 

 

 

Using media other than the recommended media can 

cause media jams, blurred images, or printer failure. 

The printer can hold two large rolls of media with either the same or 
different sizes.  Refer to the ColorgrafX X2 Inkjet Graphics 
Applications Guide to acquire a list of sizes by media type. 

The following procedure outlines the process to load media in the 
printer. 

 

 

 

 

1.

  If changing media type, be sure to change the media type 

before closing the covers.

   

 

After you load the media and close the covers, the printer 
will automatically load media through the printer and attempt
to cut it as part of the self-test. If you have not set the cutter,
for example, to handle the newly loaded media correctly, you
could cause a media jam when the printer attempts to cut 
the new media. 

 

  2.  Insert an end cap into one end of the new media roll until it 

is firmly seated, being careful not to damage the other, 
exposed end of the media roll.  The end cap should be snug,
but not jammed on the roll for optimum use.