Gestetner c7006dw Operating Guide
Troubleshooting
74
4
Replacing the Photoconductor
Unit
Unit
The message shown below indicates
that the photoconductor unit is ap-
proaching the end of its life.
that the photoconductor unit is ap-
proaching the end of its life.
IPDL-C
Change PCU
You can still continue to use the cur-
rent photoconductor unit if you are
satisfied with the quality of the out-
put being produced by the printer.
When the printed image starts look-
ing soiled (horizontal lines along the
edges of the page, for example), re-
place the photoconductor unit as
soon as possible.
rent photoconductor unit if you are
satisfied with the quality of the out-
put being produced by the printer.
When the printed image starts look-
ing soiled (horizontal lines along the
edges of the page, for example), re-
place the photoconductor unit as
soon as possible.
R
WARNING:
R
CAUTION:
Important
❒ Exposing the photoconductor unit
to light for too long can reduce its
performance. Replace the unit as
quickly as possible.
performance. Replace the unit as
quickly as possible.
Note
❒ Before removing the photoconduc-
tor unit from the printer, spread
paper or some other material
around the area you are working
to keep toner from making floor
dirty.
paper or some other material
around the area you are working
to keep toner from making floor
dirty.
❒ The “Change PCU” message is
based on a printed page counter
kept internally by the printer. It is
meant as a general guide to photo-
conductor unit life only. Actual
photoconductor unit life depends
on the printing conditions.
kept internally by the printer. It is
meant as a general guide to photo-
conductor unit life only. Actual
photoconductor unit life depends
on the printing conditions.
A
Remove the new photoconductor
unit from the box.
unit from the box.
B
Pull the red tab to remove the pro-
tective sheet from the new photo-
conductor unit.
tective sheet from the new photo-
conductor unit.
C
Turn off the printer's power switch.
D
Push the front cover release but-
ton and open the front cover.
ton and open the front cover.
•
Do not incinerate the photo-
conductor unit. Toner dust
might ignite when exposed to
an open flame.
conductor unit. Toner dust
might ignite when exposed to
an open flame.
•
Disposal can take place at our
authorized dealer or at appro-
priate collection sites.
authorized dealer or at appro-
priate collection sites.
•
If you dispose the used photo-
conductor unit yourself, dis-
pose of it according to your
local regulations.
conductor unit yourself, dis-
pose of it according to your
local regulations.
•
When accessing the inside of the
machine, do not touch any sec-
tions other than those specified
in this manual. If you do, it might
result in receiving a burn or inju-
ry.
machine, do not touch any sec-
tions other than those specified
in this manual. If you do, it might
result in receiving a burn or inju-
ry.
TFWX472E
TFWX080E