Gestetner c7006dw Operating Guide
Troubleshooting
76
4
H
Holding the green inset grips of
the new photoconductor unit, in-
sert the unit into the photocon-
ductor unit holder.
When inserting the photoconduc-
tor unit, be careful not to damage
the surface of it.
the new photoconductor unit, in-
sert the unit into the photocon-
ductor unit holder.
When inserting the photoconduc-
tor unit, be careful not to damage
the surface of it.
Note
❒ The white powder on the photo-
conductor unit is to protect it af-
ter installation into the printer.
This white powder does not
have any adverse effect on the
interior of the printer.
ter installation into the printer.
This white powder does not
have any adverse effect on the
interior of the printer.
I
Holding the green inset grips of
the new photoconductor unit,
push the unit back to its original
position.
the new photoconductor unit,
push the unit back to its original
position.
J
Fasten the screws using the screw
driver to fix the photoconductor
unit.
driver to fix the photoconductor
unit.
K
Close the front cover.
Confirm that the front cover closes
properly.
Confirm that the front cover closes
properly.
L
Turn on the printer’s power switch.
Replacing the Fuser Oil Bottle
and Ozone Filter
and Ozone Filter
Replace the oil bottle and ozone filter
whenever the following messages ap-
pear on the panel display.
whenever the following messages ap-
pear on the panel display.
IPDL-C
Add FuserOil
Add Fuser Oil
There are the fuser oil bottle and the
ozone filter in the Fuser Oil Type306
includes a fuser oil bottle and ozone
filters.
ozone filter in the Fuser Oil Type306
includes a fuser oil bottle and ozone
filters.
R
WARNING:
R
CAUTION:
Important
❒ There are three ozone filters in this
printer. Two of them are set inside
in the front, one of them is set in
the rear. Be careful when replacing
the ozone filters as the front side
filter is a different shape from the
rear side filter.
in the front, one of them is set in
the rear. Be careful when replacing
the ozone filters as the front side
filter is a different shape from the
rear side filter.
TFWX305E
•
Do not incinerate the oil bottle.
This action could cause a fire
or getting burned.
This action could cause a fire
or getting burned.
•
Spilt oil is very slippery. If oil
is spilt, wipe it with alkaline
cleaner. Otherwise, the oily
surfaces can create the dan-
ger of slipping and personal
injury.
is spilt, wipe it with alkaline
cleaner. Otherwise, the oily
surfaces can create the dan-
ger of slipping and personal
injury.
•
When accessing the inside of the
machine, do not touch any sec-
tions other than those specified
in this manual. If you do, it might
result in receiving a burn or inju-
ry.
machine, do not touch any sec-
tions other than those specified
in this manual. If you do, it might
result in receiving a burn or inju-
ry.