Gestetner cs331 Service Manual
1
2
3
4
5
6
7
8
9
10
11
12
9-22
WHEN THE GRAPHIC SYMBOLS FLASH ON THE TOUCH PANEL
3
Pull out the grip of the saddle stitch holder ( ) toward
you and turn it ( ) 90
o
clockwise in the direction of
the arrow.
4
Remove the empty staple case and set a new one.
- Replace both staple cases with new ones.
- Do not remove the seal holding the staples before the staple
case is set in the cartridge.
5
Return the saddle stitch holder and the saddle
stitching unit to their respective original positions.
6
Make sure that the finisher is attached to the copier
firmly and that LD, LG or LT-R size paper is set in
the copier.
- If one of the above paper sizes is not set, test stapling cannot
be performed.
If test stapling fails to be performed and the following
message remains displayed, repeat the above procedure
from steps 1 to 7.
message remains displayed, repeat the above procedure
from steps 1 to 7.
Set staple cartridge
2
Slide out the saddle stitch unit carefully toward the
front.
7
Close the lower cover of the finisher. Test stapling
is then automatically performed on a blank sheet.
- This operation is carried out to avoid empty stitching.
5. ADDING STAPLES (OPTIONAL) (Cont.)