Gestetner dsc332 Operating Guide

Error & Status Messages on the Display Panel

27

Finisher is in use for another 
function. Please wait.

The finisher is in use by anoth-
er function, such as the copier 
function.

Wait until the other function 
has finished using the finisher.

Following output tray is full. 
### Remove the paper. ###

The indicated output tray is 
full.

❒ “###” in the message rep-

resents a output tray.

Remove the paper.

HDD has a problem.

An error has occurred in the 
hard disk drive.

Turn off the main power 
switch, and back on again. If 
the message appears again, 
contact your sales or service 
representative.

HDD has not been installed.

Locked Print was performed 
without the hard disk in-
stalled, or the hard disk is 
damaged.

Contact your sales or service 
representative.

HDD is full.

The maximum hard disk area 
size for form/font has been ex-
ceeded.

Delete unused form /font 
types.

An HDD overflow error oc-
curred during Sample Print or 
Locked Print.

Delete some stored files, or re-
duce the size of the file to be 
downloaded.

Wireless LAN has a problem. IEEE 802.11b interface unit 

was not inserted when the ma-
chine was turned on, or it was 
pulled out after the machine 
turned on.

Turn off the machine and 
check the IEEE 802.11b inter-
face unit is inserted correctly. 
Then, turn the machine on 
again. If the message appears 
again, call your service center.

LCT has a problem. Turn 
Main Power Switch off then 
on. If the error appears again, 
call service representative.

An error has occurred in the 
Large Capacity Tray (LCT).

Turn off the main power 
switch, wait five minutes, and 
on again. If the message ap-
pears again, call your sales or 
service representative.

dLower Staple is almost 
empty.

There are only a few staples 
left in the lower stapler.

Load more staples.

NV-RAM has a problem.

An error has occurred in the 
NV-RAM.

Turn off the main power 
switch, and back on again. If 
the message appears again, 
call your sales or service repre-
sentative.

Output tray has been 
changed.

The output tray has been 
changed because of the paper 
size limitation of the selected 
tray.

Select the correct output tray.