Gestetner dsc332 Operating Guide
Reception
87
5
Receiving messages unconditionally
If one of the conditions listed below occurs, the machine receives all fax messag-
es using Substitute Reception.
es using Substitute Reception.
Receiving messages according to parameter-specified settings
If one of the conditions listed below occurs, the machine receives only those mes-
sages that match the conditions specified in the User Parameters. See p.161 “Us-
er Parameters” (switch 05, bit 2,1).
sages that match the conditions specified in the User Parameters. See p.161 “Us-
er Parameters” (switch 05, bit 2,1).
You can specify the following conditions with the User Parameters. See p.161
“User Parameters” (switch 05, bit 2,1).
“User Parameters” (switch 05, bit 2,1).
❖
❖
❖
❖ When Own Name or Own Fax Number is received
The machine switches to Substitute Reception only when the sender has pro-
grammed their Own Name or Own Fax Number. If the power is switched off
for more than an hour, all the messages stored in memory are deleted. In that
case, the Power Failure Report or the Journal can be used to identify which
messages are lost so you can ask the senders to transmit them again.
grammed their Own Name or Own Fax Number. If the power is switched off
for more than an hour, all the messages stored in memory are deleted. In that
case, the Power Failure Report or the Journal can be used to identify which
messages are lost so you can ask the senders to transmit them again.
Important
❒ If a sender has not programmed their Own Name or Own Fax Number, the
machine may fail to receive an important fax message. We recommend
that you ask important senders to program an Own Name or Own Fax
Number in advance.
that you ask important senders to program an Own Name or Own Fax
Number in advance.
Problems
Causes
Solutions
x is lit.
Paper is jammed.
Remove the jammed paper.
See “
xClearing Misfeeds”, General
Settings Guide.
The machine is printing
with other function.
with other function.
The machine is busy print-
ing with other function.
ing with other function.
The message will be automatically
printed after the current job finishes.
printed after the current job finishes.
The message “
Follow-
ing output tray is
full. Remove pa-
per.
full. Remove pa-
per.
” appears.
The output tray is full.
Remove paper from the output tray.
M is lit.
The cover is open.
Close the cover shown in the display.
Problems
Causes
Solutions
B is lit.
All trays out of paper.
Add paper. See “
BLoading Paper” ,
General Settings Guide.
D is lit.
Toner is empty.
Replace the toner cartridge. See
“
“
DAdding Toner”, General Settings
Guide.
The message “
This
tray is out of
order.
order.
” appears.
All trays out of action.
Call your service representative.
JptrC1FaxGBCombine_F_FM.book Page 87 Thursday, August 21, 2003 11:33 AM