Gestetner dsc332 Operating Guide
Error & Status Messages on the Display Panel
27
4
Finisher is in use for another
function. Please wait.
function. Please wait.
The finisher is in use by anoth-
er function, such as the copier
function.
er function, such as the copier
function.
Wait until the other function
has finished using the finisher.
has finished using the finisher.
Following output tray is full.
### Remove the paper. ###
### Remove the paper. ###
The indicated output tray is
full.
full.
Note
❒ “###” in the message rep-
resents a output tray.
Remove the paper.
HDD has a problem.
An error has occurred in the
hard disk drive.
hard disk drive.
Turn off the main power
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
switch, and back on again. If
the message appears again,
contact your sales or service
representative.
HDD has not been installed.
Locked Print was performed
without the hard disk in-
stalled, or the hard disk is
damaged.
without the hard disk in-
stalled, or the hard disk is
damaged.
Contact your sales or service
representative.
representative.
HDD is full.
The maximum hard disk area
size for form/font has been ex-
ceeded.
size for form/font has been ex-
ceeded.
Delete unused form /font
types.
types.
An HDD overflow error oc-
curred during Sample Print or
Locked Print.
curred during Sample Print or
Locked Print.
Delete some stored files, or re-
duce the size of the file to be
downloaded.
duce the size of the file to be
downloaded.
Wireless LAN has a problem. IEEE 802.11b interface unit
was not inserted when the ma-
chine was turned on, or it was
pulled out after the machine
turned on.
chine was turned on, or it was
pulled out after the machine
turned on.
Turn off the machine and
check the IEEE 802.11b inter-
face unit is inserted correctly.
Then, turn the machine on
again. If the message appears
again, call your service center.
check the IEEE 802.11b inter-
face unit is inserted correctly.
Then, turn the machine on
again. If the message appears
again, call your service center.
LCT has a problem. Turn
Main Power Switch off then
on. If the error appears again,
call service representative.
Main Power Switch off then
on. If the error appears again,
call service representative.
An error has occurred in the
Large Capacity Tray (LCT).
Large Capacity Tray (LCT).
Turn off the main power
switch, wait five minutes, and
on again. If the message ap-
pears again, call your sales or
service representative.
switch, wait five minutes, and
on again. If the message ap-
pears again, call your sales or
service representative.
dLower Staple is almost
empty.
empty.
There are only a few staples
left in the lower stapler.
left in the lower stapler.
Load more staples.
NV-RAM has a problem.
An error has occurred in the
NV-RAM.
NV-RAM.
Turn off the main power
switch, and back on again. If
the message appears again,
call your sales or service repre-
sentative.
switch, and back on again. If
the message appears again,
call your sales or service repre-
sentative.
Output tray has been
changed.
changed.
The output tray has been
changed because of the paper
size limitation of the selected
tray.
changed because of the paper
size limitation of the selected
tray.
Select the correct output tray.
Messages/Second messages
Causes
Solutions