Lexmark X644e Reference Guide
Reports
25
Using MFP menus
Universal Setup
These menu items are used to specify the height and width of the Universal Paper Size. By specifying the height and width
for Universal Paper Size, the MFP uses the Universal setting like other paper sizes, including support for duplex and n-up.
For more information on n-up, see Multipage Print.
for Universal Paper Size, the MFP uses the Universal setting like other paper sizes, including support for duplex and n-up.
For more information on n-up, see Multipage Print.
Reports
Note: After a report prints, the MFP returns to the home screen.
Menu item
Purpose
Values and descriptions
Units of Measure
Determines the unit of measure
used to enter the Universal Height
and Width.
used to enter the Universal Height
and Width.
Inches
Millimeters
Inches is the US default, and
Millimeters is the international default.
Millimeters is the international default.
Portrait Width
Sets the portrait width of the
universal media.
universal media.
Note: If the value set exceeds the
maximum width, the MFP uses the
maximum value allowed in inches or
millimeters.
maximum width, the MFP uses the
maximum value allowed in inches or
millimeters.
3 inches to
14.17 inches in 0.01
inch increments
14.17 inches in 0.01
inch increments
76 mm to 360 mm in
1 mm increments
1 mm increments
Shows either inches or millimeters
from Units of Measure setting;
8.5 inches is the US default, and
216 mm is the international default.
from Units of Measure setting;
8.5 inches is the US default, and
216 mm is the international default.
Portrait Height
Sets the portrait height of the
universal media.
universal media.
Note: If the value set exceeds the
maximum height, the MFP uses the
maximum value allowed in inches or
millimeters.
maximum height, the MFP uses the
maximum value allowed in inches or
millimeters.
3 inches to
14.17 inches in 0.01
inch increments
14.17 inches in 0.01
inch increments
76 mm to 360 in
1 mm increments
1 mm increments
Shows either inches or millimeters
from Units of Measure setting;
14 inches is the US default, and
356 millimeters is the international
default.
from Units of Measure setting;
14 inches is the US default, and
356 millimeters is the international
default.
Feed Direction
Specifies the feed direction of the
Universal Paper Size.
Universal Paper Size.
Short Edge*
Long Edge
Feed Direction is only shown if the
Long Edge value is available. Long
Edge exists if the longest edge is
shorter than the maximum physical
width that the tray can accommodate.
Long Edge value is available. Long
Edge exists if the longest edge is
shorter than the maximum physical
width that the tray can accommodate.