Maxent mx-20v2 User Manual
18
Connecting a PC
Using RGB Video Input
Connect the red (R) and white (L) audio jacks
from the PC to the 3.5 mm ear-phone audio-in
jack located next to the RGB connector.
from the PC to the 3.5 mm ear-phone audio-in
jack located next to the RGB connector.
For most PCs, connect the 15-pin D-Sub RGB
IN Cconnector from the back of the PC to the
RGB connector located on the back of the
monitor.
IN Cconnector from the back of the PC to the
RGB connector located on the back of the
monitor.
3.5mm
Setting Up Your Monitor Using Plug and Play
This monitor adheres to VESA Plug and Play standard to eliminate complicated and time consuming setup of
monitors. This monitor identifies itself to the computer and automatically sends the PC its Extended Display
Identification Data (EDID) using Display Data Channel (DDC) protocols.
monitors. This monitor identifies itself to the computer and automatically sends the PC its Extended Display
Identification Data (EDID) using Display Data Channel (DDC) protocols.
How to Set up Your PC for Use with Monitor (Windows)
The display settings for a typical Windows-based computer are shown below; however, actual screens on your
computer will differ depending on the version of Windows and video card equipped with the computer. Even
though the actual screen may look different from example displayed below, basic set-up routine will apply in
most cases.
computer will differ depending on the version of Windows and video card equipped with the computer. Even
though the actual screen may look different from example displayed below, basic set-up routine will apply in
most cases.
Go to Window’s CONTROL PANEL by clicking:
START, SETTINGS, CONTROL PANEL. The
CONTROL PANEL Window is displayed. Select
the DISPLAY icon from this window.
START, SETTINGS, CONTROL PANEL. The
CONTROL PANEL Window is displayed. Select
the DISPLAY icon from this window.
Display Connections