Pioneer krp-500m User Guide

En

To return all learned and preset codes to the defaults (PIONEER), follow the steps below.

To exit before the reset is complete, press the 

EDIT button again. The reset is cancelled if no action is taken within 

60 seconds. Switching the Mode during this procedure also cancels the reset.

The flat panel display’s remote control has a bank of buttons specifically for controlling a Pioneer receiver. The 
active buttons, left to right, are as follows:

1 ) Simultaneously press the 

EDIT and MONITOR 

 buttons to begin.

Selection can be in any mode.

2 ) Press the 

Yellow button to clear added codes.

Confirm that the selected mode indicator flashes.

The remote control enters the Manufacturing Reset mode. The 
reset is complete when the mode indicator flashes once. The 
remote control then returns to normal operation.

Note: The panel’s remote control may not control or have complete 

control of some equipment listed in the tables.

• RECEIVER STANDBY/ON

(turns the Pioneer Receiver On/Off)

• RECEIVER INPUT

(cycles through/selects an input)

• RECEIVER VOL –

(adjusts the volume lower)

• RECEIVER VOL +

(adjusts the volume higher)

KRP-600M_500M.book  Page 52  Monday, June 16, 2008  10:23 AM