Pioneer krp-500m User Guide

Page of 326
59
En
Use Other Equipment With Your Flat Panel Display
 06
Englis
h
6.3.2 Specify the HDMI Input Type
To select a signal type, follow the steps below.
1 ) Select the Input for the connected equipment.
Press the INPUT button (remote control or panel) until the correct input is showing (INPUT 5 or INPUT 6).
2 ) Access 
Input Setup 2/2  through the Input Setup menu.
3 ) Select INPUT
 5(HDMI 1) or INPUT 6(HDMI 2).
4 ) Select 
Signal Type from the submenu.
5 ) Select the appropriate option.
6 ) Press 
EXIT to exit the menu.
In Video mode, the image is over-scanned (enlarged) but the panel automatically switches to PC when receiving 
computer signals. In PC mode, the image displays in full size for optimum image quality.
6.3.3 Specify a Digital HDMI Signal Type
For the correct digital video signal type, check the operating manual that came with the other equipment.  
To assign the type of digital signal,follow the steps below.
1 ) Access 
Input Setup 2/2  through the Input Setup menu.
2 ) Select INPUT
 5(HDMI 1) or INPUT 6(HDMI 2).
3 ) Select 
Video from the submenu.
4 ) Select the type of digital video signal recommended for the attached device.
5 ) Press 
EXIT to close the menu.
If an image fails to appear, specify another digital video signal type. Type parameters other than Auto need to be 
checked for natural colorings.
Option
Description
Video
use except when a PC is connected (default)
PC
when a PC is connected to HDMI input terminal
Type
Description
Auto
automatically identifies input digital signals
1 (YUV422)
Digital Component Video signals (4:2:2) locked
2 (YUV444)
Digital Component Video signals (4:4:4) locked
3 (RGB16-235)
Digital RGB signals (16 to 235) locked
4 (RGB0-255)
Digital RGB signals (0 to 255) locked
Video (over-scan)
PC (under-scan)
KRP-600M_500M.book  Page 59  Monday, June 16, 2008  10:23 AM