Pioneer pdp-4270hd User Guide

Preparation

English

Connecting the power cord

Connect the power cord after all component connections have been completed.

Plasma Display (rear view)

NOTE

• Always turn off the power of the Plasma Display when

connecting or disconnecting power cords.

• Disconnect the power cord from the power outlet when the

Plasma Display System is not going to be used for a long
period of time.

Routing cables

Attaching speed clamps to the main unit

Attach the speed clamps using any of the 4 holes you prefer (50
inches, 3 holes; 42 inches, 2 holes) marked with below,
depending on your routing system.
for PDP-6072HD/PDP-6071HD/PDP-6070HD

for PDP-5072HD/PDP-5071HD/PDP-5070HD

for PDP-4272HD/PDP-4271HD/PDP-4270HD

Attaching and removing speed clamps

Insert

[1] into an appropriate hole on the rear of the Plasma

Display and snap

[2] into the back of [1] to lock the clamp.

Speed clamps are designed to be difficult to undo once in
place. Please attach them carefully.
Use pliers to twist the clamp 90º, pulling outward. The clamp
may deteriorate over time and become damaged if removed.

NOTE

• Use the supplied bead bands and speed clamps as

necessary.

• When tidying up your speaker cables, make sure to bundle

them so that they are not subjected to any pressure.

Power cord

AC IN terminal is located on the
upper edge of the compartment.

Noise filter
Partially eliminates noise
caused by the power source.

Rear view

Speaker cable

When the speaker is installed under the display panel of the PDP-5072HD/PDP-5071HD/PDP-5070HD:

Bead band

CAUTION

• Use only the supplied power cord.
• Be sure to use the specified power supply voltage;

neglecting this can result in fire or electric shock.

• For the Plasma Display System, a three-core power

cord with a ground terminal is used for efficient
protection. Always connect the power cord to a
three-pronged outlet and make sure that the cord
is properly grounded.

PDP6070HD.book Page 31 Friday, May 19, 2006 5:01 PM