Pioneer pdp-4270hd User Guide

En

Unless you set up TV channels that you can watch under the 
current conditions, you cannot tune in those channels. For the 
procedure, see “Setting up TV channels” on page 43. 

• When watching a digital TV program, you may see 

emergency alert messages scrolling at the top of the screen. 
Those messages are broadcasted by TV stations as 
necessary when in emergency situations.

After confirming that the Mode switch on the remote control 
unit has been set to “TV”, press 

ANT on the remote control unit 

to select antenna A or B.

• Make this selection depending on the connections to the 

antenna input terminals at the rear of the Plasma Display 
(page 29). 

To increase the channel number, press 

CH + on the remote 

control unit. To decrease the channel number, press 

CH –.

•

CHANNEL +/– on the Plasma Display operates the same as 

CH +/– on the remote control unit.

• Press 

CH RETURN to switch the currently tuned channel to 

the previously tuned channel. 
Press 

CH RETURN again to restore the currently tuned 

channel.

Select channels directly by pressing buttons 

0 to 9. To select 

subchannels, also use the • (dot) button.

• To select channel 5 (1-digit channel), press 

5.

• To select channel 25 (2-digit channel), press 

2 then 5.

• To select channel 125 (3-digit channel), press 

1, 2, then 5.

• To select subchannel 10.01, press 

1, 0, • (dot), 0, then 1. 

• To select subchannel 10.001 (for cable TV), press 

1, 0, 

• (dot), 0, 0, then 1. 

• After entering a channel or subchannel number, you may 

press 

CH ENTER to tune in the channel more quickly.

• Each time you change a channel, a channel banner appears 

that shows information about the currently selected 
channel. To clear the channel banner, press

 INFO.

• If you do not setup the TV Guide On Screen™ system, the 

channel banner may not display certain types of program 
information.

PDP6070HD.book  Page 33  Friday, May 19, 2006  5:01 PM