Epson DFX-9000 User Guide
20 Default-setting Mode
9.
If you want to save the settings, select
Yes
by pressing the
Set
U
(
Tear Off
)
button. If you don’t want to save the settings, select
No
by pressing the
Set
D
(
Top of Form
) button. The printer exits SelecType mode.
Note:
If you turn off the printer prior to exiting the SelecType mode, any changes you have
made are canceled and not saved.
If you turn off the printer prior to exiting the SelecType mode, any changes you have
made are canceled and not saved.
Default-setting Mode
Use the Default-setting mode if you need to adjust the print head position for
printing on uneven forms or to choose which control panel buttons to lock
when Lock-out mode is turned on. (See page 21 for more information about
Lock-out mode.)
printing on uneven forms or to choose which control panel buttons to lock
when Lock-out mode is turned on. (See page 21 for more information about
Lock-out mode.)
Continuous forms with labels
If you are printing on forms of varying thicknesses—for example, a form that
includes a label in addition to standard printing—you may need to adjust the
includes a label in addition to standard printing—you may need to adjust the
Forms w/labels
setting. By defining the position of the label, you tell the printer
where it needs to raise the print head to accommodate the greater thickness as it
prints over the label.
prints over the label.
Before you can change the settings for continuous forms with labels, use
SelecType as described on page 19 to make sure the
SelecType as described on page 19 to make sure the
Forms w/labels
setting is set
to
On
.
Note:
You do not need to change these settings for printing label sheets of uniform thickness.
You do not need to change these settings for printing label sheets of uniform thickness.
*
Adjusts the platen gap for printing on label carrier (base sheet).
** Adjusts the platen gap for printing on labels affixed to label carrier.
Lock-out mode settings
Setting
Options (default in bold)
Label base position
Paper left edge, First dot
Label top position
0 to 4752/216 (0 to 22” in 1/216-inch increments)
Label length
0 to 4752/216 (0 to 22” in 1/216-inch increments)
Label left position
0 to 1440/120 (0 to 12” in 1/120-inch increments)
Label width
0 to 1440/120 (0 to 12” in 1/120-inch increments)
Base sheet PG (platen gap)
position number
position number
0 to 14*
Label paper PG (platen gap) position
number
number
0 to 14**
Button function
Settings (default in bold)
Pause
Unlock, Lock
Micro Feed
Unlock, Lock
Load
Unlock, Lock
LF Unlock,
Lock
FF Unlock,
Lock
Top of Form
Unlock, Lock
Tear Off
Unlock, Lock
Font Unlock,
Lock
Pitch Unlock,
Lock
Front/Rear Unlock,
Lock
Menu Unlock,
Lock
Reset Unlock,
Lock