Epson 1000 Reference Guide

If you are using legal-size paper, you may find that the

printable area is smaller than you expect. To clear this

problem, decrease the RX-BUFFER SIZE option in

SelecType or increase the available RAM. See the discussion

of RX-BUFFER SIZE in Chapter 4, “SelecType,” or see “The

Memory Chip Sets” later in this chapter.

If you set EMULATION to one of the Intelligent Emulation

Switch (IES) settings, be sure to turn off the start page

printing feature in PostScript. If both the IES feature and

the start page printing feature are on, the printer prints the

start page each time it switches from HP emulation to

PostScript.

Follow these guidelines when using the optional Epson GL

identity card.

The GL emulation requires at least 1.5 megabytes (MB) of

RAM. This means you need to add at least 1.0MB RAM to

an ActionLaser 1000 or 0.5MB RAM to an ActionLaser 1500

before you can use GL emulation. See “The Memory Chip

Sets” later in this chapter.

The printer ignores device control commands from optional

interfaces even if the interface is serial. Use the printer’s

serial interface to enable the additional device control

commands. (If you have an ActionLaser 1000, use your

parallel interface.)