Epson 1080 Installation Instruction
2
Setting Up the Equipment and Displaying an Image
1. Unpack the HQV video processor and attach the serial number sticker included with it to
the HQV User Manual.
2. Connect at least one video source to the video processor.
3. Connect an HDMI cable from the video processor to the projector.
4. Plug in the power cord for the video processor. Make sure batteries are installed in the
HQV remote control.
5. Set up the projector and turn it on as outlined below. For details, see the projector User’s
Guide.
■
Remove the protective lens pad from the projector, then remove the lens cap.
■
Make sure batteries are installed in the Epson remote control.
■
Plug in the power cord, then turn on the power switch on the back of the projector.
Once the projector is receiving power, press the
Once the projector is receiving power, press the
On
button on the Epson remote
control to turn it on.
6. Press the
Pattern
button on the Epson remote control, then adjust the image as outlined
below.
■
Focus and zoom the image.
■
Position the image on the screen. If possible, keep the projector level and position the
image using only the lens shift dials.
image using only the lens shift dials.
Caution: Do not try to move the lens by hand, or you may damage the projector. Always
use the lens shift dials to change the lens position.
use the lens shift dials to change the lens position.
HDMI OUT
Video processor
Projector