Epson 1080 Installation Instruction
6
4. Windows XP: At the next page, select
Install from a list or specific location
and click
Next
. Then select
Search for the best drivers in these locations
. Make sure the
checkbox for
Search removable media
is selected.
Windows 2000: Select
Search for a suitable driver for my device
. Click
Next
, then
select
CD-ROM drives
.
5. Click
Next
to install the driver, then click
Finish
when done.
6. You see the Found New Hardware screen again. Repeat steps 3 through 5 to install a
second driver.
7. Remove the CD from your CD/DVD drive.
Using the Calibration Software
Use the calibration software to adjust the ISF Day and Night settings for each connected
video source.
video source.
1. Launch the
Config Tool
located in the Silicon Optix program folder.
2. When the program opens, click the
Connect
button, select
USB
as the connection
method, and click
OK
.
3. Select either
Day
or
Night
, depending on the ISF configuration you want to
adjust.
4. Click the tab that corresponds to the video source you want to adjust.
5. For the Input Parameters, adjust the
Contrast
,
Brightness
,
Color
,
Hue
, and
Sharpness
as needed.
6. If you want to eliminate overscan, reduce all four
Overscan
settings to 0 (left, right, top,
and bottom). If you want the image overscanned by about 2.5 to 3 percent, leave the
settings as they are.
settings as they are.
7. For the Output Parameters, you need to make sure the
Luma
is set correctly for all digital
video sources to prevent clipping. Set the
Peak
to 235 and the
Base
to 16.
Note: RGB Peak and Base parameters should be adjusted, if necessary, only with photometric
equipment. See the HQV ISF Certified Calibration Controls Dealer Guide for details.
equipment. See the HQV ISF Certified Calibration Controls Dealer Guide for details.
8. When you’re done making adjustments, click the
Disconnect
button to exit the
software.