Sony KLV-26HG2 Operating Guide

12

Installing and Connecting the TV

Use this hookup if:

• You subscribe to a cable TV system that does not require a cable box.

Connect the CATV cable to the VCR’s IN jack.

Using the supplied 75-ohm coaxial cable, connect the VCR’s OUT jack
to the TV’s VHF/UHF jack.

Using AUDIO and S VIDEO cables, connect the VCR’s AUDIO and S
VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks.

• If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S

VIDEO cable.

When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make sure
“Auto YC” in the 

 (Setup) menu is set to “On” to view the S VIDEO input (see below).

• You can also use the VIDEO 2 IN jacks located on the left side of the TV to connect your VCR.

Using the menu, you can select the jack from which the TV receives the input
signal. You can set it for each video input (VIDEO 1 IN and VIDEO 2 IN)
separately. The TV is factory set to receive S VIDEO input signals.

Press TV/VIDEO repeatedly until the desired video input appears.

Press MENU.

Press 

V/v to select 

 (Setup), then press 

.

Press 

V/v to select “Auto YC,” then press 

.

To watch the pictures input from the S VIDEO input jack:
Press 

V/v to select “On,” then press 

.

To watch the pictures input from the VIDEO input jack:
Press 

V/v to select “Off,” then press 

.

Press MENU to exit the menu screen.

Cable

75-ohm
coaxial cable
(supplied)

S VIDEO cable
(not supplied)

VIDEO (yellow)

AUDIO-L (white)

AUDIO-R

(red)

VCR

S VIDEO

Rear of TV

75-ohm coaxial
cable (supplied)

AUDIO cable (not supplied)