Sony ICS-SP20 User Manual

ICS-SP20 User Manual 

 

9

 

 

 

-- Selects the current (default) volume level 

-- Specifies the strength of 3D-spatial effect 

 

 
 

 

 

-- Specifies the default channel, which will be selected upon ICS-SP20 power-up. 

If this default channel is set to “0” -- the default channel will be the last channel 
selected before the ICS-SP20 was powered off. 

-- Change the text label assigned to the current channel. This label is shown (if 

enabled) on screen, along with the channel number, when the ICS-SP20 is 
switched to this channel. Display of labels and channel numbers can be globally 
disabled on enabled, see the subsequent menu options. 

-- Setting to enable will show up to an 8 character label specific to the channel 

when changing channels. 

Show Number  -- Setting to enable will show up the channel number when changing channels. 
Mode 

-- Select tuner mode (channels allocation) to use, among broadcast and several 

cable options. 

Tune Channels  -- Scans the channels, looking for valid signal presence, and “remembers” which 

channels are valid and which are not. This “validity mask” is used then for 
channel browsing using channel +/- buttons (so that a user browses through the 
defined channels only). Note that before this operation ICS-SP20 must be 
connected to RF-antenna or cable TV.