Sony DIR-TC1 Manual
11
GB
You can hang the IR transmitter and IR receiver
on a wall when:
on a wall when:
– there is an obstruction between the IR
transmitter and the IR receiver.
– people often pass between the IR transmitter
and the IR receiver.
When hanging both the IR transmitter and IR
receiver, adjust the position of the IR transmitter
after deciding the position of the IR receiver.
receiver, adjust the position of the IR transmitter
after deciding the position of the IR receiver.
Installing the IR transmitter
on a wall
on a wall
1
Rotate the stand of the IR transmitter.
2
Install 2 commercially available screws
in the wall so as to protrude 4 mm (
in the wall so as to protrude 4 mm (
3
/
16
inch).
Install the screws 30 mm
(1
3
/
16
inches)
apart.
3
Hang the IR transmitter by the hole on
the bottom of the stand on the screw.
the bottom of the stand on the screw.
Make sure that the IR transmitter does not
move after installation.
move after installation.
Tip
• You can store the cords in the troughs in the bottom
of the stand.
Note
• Use screws suitable for the material and strength of
the wall.
• Do not install the IR transmitter on a wall of low
strength.
• Sony is not liable for any damage or accident incurred
by incorrect installation (i.e. low strength wall, etc.),
incorrect use of this product, or natural disaster.
incorrect use of this product, or natural disaster.
• When connecting/disconnecting the cord, detach the
IR transmitter from the wall first.
Installing the IR
Transmitter and the IR
Receiver on a Wall
Transmitter and the IR
Receiver on a Wall
Stand
IR transmitter
30 mm (1
3
/
16
inches)
4 mm
(
3
/
16
inch)
5 to 7 mm
(
7
/
32
to
9
/
32
inch)
IR transmitter
Stand
Troughs
Stand
continued