D-Link DAS-3224_revB Software Guide
錯誤! 尚未定義樣式。
19
Chapter 4
Quick Start Operation
This chapter describes the command “wizard” which provides key feature to build up the data
connection of the system, the “wizard” command gives convenient to operator to avoid the complicate
of configuration setting.
z
connection of the system, the “wizard” command gives convenient to operator to avoid the complicate
of configuration setting.
z
Deploying the Subscriber Data Connection
z
Deploying the GE Network Management Connection
z
Modify and Remove the Connection Status
z
Diagnosis the Data Connection
z
Monitoring the Subscriber Data Connection Status
Deploying the Subscriber Data Connection
The ‘wizard deploy’ command guide you to deploying the ATM data connection where you specify
and the encapsulation mode.
and the encapsulation mode.
Table 4-1
Configuring General Subscriber Interface Data Connection
Use this command to create Network Ethernet parameters.
#wizard deploy <user <u> | all> vpi <vpi> vci <vci>[encap vcmux | llcmux]
Parameters
Task
<user <u> | all>
Identify the specific user or entire device.
Type: Mandatory
Valid values: 1 ~ 48 and all
vpi <vpi>
Virtual Path Identifier. In order to set, the VPI value shall be the new VPI value. Also, the VPI and
VCI value cannot be modified along in one command.
VCI value cannot be modified along in one command.
Type: Mandatory
Valid values: 0 ~ 255
vci <vci>
Virtual Circuit Identifier. In order to set, the VCI value shall be the new VCI value. Also, the VPI and
VCI value cannot be modified along in one command.
VCI value cannot be modified along in one command.
Type: Mandatory
Valid values: 1 ~ 65535
[encap vcmux | llcmux]
This specifies the data multiplexing method to be used over the AAL5 SSCS layer.
Type: Optional
Default Value: llcmux
The wizard deploy command automatically creates the ADSL line profile, ATM port connection, ATM
VC connection, EoA interface, and Bridge interface in order to have your user interface satisfy in
optimal value.
Example 4
#wizard deploy user 1 vpi 0 vci 33 encap llcmux
$modify adsl line intf ifname dsl-1 disable
Warning: Status already set to specified value
enable|disable
$$modify adsl line profile ifname dsl-1 atucfastmaxtxrate 0x1ab3f00 atucintlmaxtxrate 0x1ab3f00
atucmaxintldelay 16 aturmaxintldelay 16
Set Done
$create atm port ifname atm-1 lowif dsl-1
DAS3series IP-DSLAM
System Configuration Guide
System Configuration Guide