D-Link DAS-3216_revB Software Guide
錯誤! 尚未定義樣式。
31
Configuring the AAL5 VC Interface
Use ‘create atm vc’ command to create a new AAL5 VC interface and defined the corresponding
lower interface (ATM port Interface) The parameters in this layer control the ATM PVC (Permanent
Virtual Channel) identifier and the encapsulation mode.
Table 6-5 lists the relative command for configuring the AAL5 VC interface.
lower interface (ATM port Interface) The parameters in this layer control the ATM PVC (Permanent
Virtual Channel) identifier and the encapsulation mode.
Table 6-5 lists the relative command for configuring the AAL5 VC interface.
Table 6-5
Configuring the ATM Port Interface
Use this command to create the AAL5 VC interface parameters.
#create atm vc ifname <aal5 ifname> lowif <atm ifname> [vpi vpi] [vci vci] [vcmux | llcmux] [channel fast |
interleaved] [enable | disable]
interleaved] [enable | disable]
Use this command to modify the AAL5 VC interface parameters
# modify atm vc ifname <aal5 ifname> [vpi vpi] [vci vci] [vcmux | llcmux] [channel fast | interleaved] [enable |
disable]
disable]
Use this command to get the AAL5 VC interface parameter setting.
#get ethernet intf [ifname interface-name]
Use this command to remove the AAL5 VC interface.
#delete ethernet intf ifname <interface-name>
Parameters
Task
ifname <aal5 ifname>
This specifies the name of the VC interface
Type: Mandatory (Create, Delete, Modify), Optional (Get)
Valid values: aal5-0 ~ aal5-384
lowif <atm ifname>
This identifies the lower ATM port interface, on which this VC interface is getting
configured.
configured.
Type: Mandatory (Create)
Valid values: atm-1 ~ atm-48
[vpi vpi]
Virtual Path Identifier. In order to modify, the VPI value shall be the new VPI value
and the admin status of VC interface shall be disabled. Also, the VPI and VCI value
cannot be modified along in one command.
and the admin status of VC interface shall be disabled. Also, the VPI and VCI value
cannot be modified along in one command.
Type: Mandatory (Create), Optional (Modify)
Valid values: 0 ~ 255
[vci vci]
Virtual Circuit Identifier. In order to modify, the VCI value shall be the new VCI
value and the admin status of VC interface shall be disabled. Also, the VPI and VCI
value cannot be modified along in one command.
value and the admin status of VC interface shall be disabled. Also, the VPI and VCI
value cannot be modified along in one command.
Type: Mandatory (Create), Optional (Modify)
Valid values: 1 ~ 65535
[vcmux | llcmux]
This specifies the data multiplexing method to be used over the AAL5 SSCS layer.
Type: Optional
Default Value: llcmux
[channel fast | interleaved]
This extension specifies the type of channel, on which the ATM VC’s cells have to be
transmitted/received, ‘fast’ means fast channel and ‘inter’ means interleaved channel.
transmitted/received, ‘fast’ means fast channel and ‘inter’ means interleaved channel.
Type: Optional
Default Value: interleaved
[enable | disable]
This specifies the Admin status of the AAL5 VC interface
Type: Optional
Default Value: enable
DAS3series IP-DSLAM
System Configuration Guide
System Configuration Guide