D-Link DAS-3216_revB Software Guide

錯誤!  尚未定義樣式。 

This chapter describes the top layer Bridge interface in CLI Ex mode. 
 
This chapter contains the following sections: 
 
z 

Configuring the Bridge Port Interface 

z 

Monitoring the Bridge Port Interface Status 

z 

Configuring the GARP Port Info 

z 

Bridge Services Administrating 

 

Use ‘create bridge port intf’ command to create a new Bridge port interface and defined the 
corresponding lower interface (EoA or Ethernet). The parameters in this layer control the bridging and 
switching capability.   
 
Table 7-1 lists the relative command for configuring the Bridge port interface. 
 

Use this command to create the bridge port interface parameters. 

#create bridge port intf ifname <ifname> portid <portid> [maxucast decvalue] [learning enable | disable] 

Use this command to modify the bridge port interface parameters 

# modify bridge port intf portid <portid> [maxucast decvalue] [learning enable | disable] 

Use this command to get the bridge port parameter setting. 

#get bridge port intf [portid portid]   

Use this command to remove the bridge port interface. 

#delete bridge port intf portid <portid> 

ifname <ifname> 

This specifies the name of the EoA or Ethernet uplink interface 

Type: Mandatory (Create, Delete, Modify), Optional (Get) 

Valid values: eoa-1 ~ eoa-384, eth-1, eth-2 

portid <portid> 

This specifies the bridge port id, start from 1 to 384. 

Type: Mandatory (Create) 

Valid values: 1 ~ 386 

[maxucast decvalue] 

This specifies the maximum number of unicast addresses which can be learned from 
this port. 

Type: Optional 

Default Values: 256 

[learning enable | disable] 

The state of learning on this bridge port. The value enable indicates that unicast MAC 
address learning is enable and the value disable indicates that unicast MAC address 
learning is disabled on this bridge port. 

Type: Optional 

Default Value: enable