D-Link DAS-3224_revB User Manual
DAS3 Series Operation Menus
17
Table 4-1
General Information Dialog Description
Item
Description
System Location
This specifies the physical location of this node.
Valid values: String of up to 100 characters (‘A’ – ‘Z’, ‘a’ – ‘z’, ‘0’ – ‘9’, ‘-’,
‘_’) and any combination of printable characters excluding ‘;’.
Valid values: String of up to 100 characters (‘A’ – ‘Z’, ‘a’ – ‘z’, ‘0’ – ‘9’, ‘-’,
‘_’) and any combination of printable characters excluding ‘;’.
System Vendor Information
This indicates the vendor-specific information.
Valid values: String of up to 100 characters (‘A’ – ‘Z’, ‘a’ – ‘z’, ‘0’ – ‘9’, ‘-’,
‘_’) and any combination of printable characters excluding ‘;’.
Valid values: String of up to 100 characters (‘A’ – ‘Z’, ‘a’ – ‘z’, ‘0’ – ‘9’, ‘-’,
‘_’) and any combination of printable characters excluding ‘;’.
Hardware version
This indicates the hardware and firmware information.
Version of the control plane
software
software
This indicates the software version of control plane.
DSP code version
The Version number of Digital Signal Processor
4.2.2
Uplink IP Configuration
IP Configuration menu allows operator to modify uplink interface setting. Figure 4-3 illustrates the IP
Configuration Dialog.
Configuration Dialog.
Figure 4-3
IP Configuration Dialog
Table 4-2
IP Configuration Dialog Description
Item
Description
Ethernet Port pull down menu
Select the Ethernet port from pull down menu.
IP Address
This specifies the network IP address of given Ethernet interface. This IP
address is for system management use only.
Valid values: Any valid class A/B/C address
address is for system management use only.
Valid values: Any valid class A/B/C address
AMS
Software Specification and Introduction Guide
Software Specification and Introduction Guide