D-Link DFL-1600 Reference Guide
Parameters
poolname
2.28.7. proxyarp_failed (ID: 05600008)
Default Severity
Log Message
Could not add dynamic ProxyARP route. NATPool <poolname>
Explanation
It was not possible to dynamically add a core route for the given IP
address.
address.
Gateway Action
None
Recommended Action
Try to configure a core route with ProxyARP manually.
Revision
1
Parameters
poolname
ip
ip
2.28.8. max_states_reached (ID: 05600009)
Default Severity
Log Message
Maximum amount of states <num_states> have been reached for
NATPool <poolname>. Replacing lingering state <replacedip>
NATPool <poolname>. Replacing lingering state <replacedip>
Explanation
The maximum configured number of states for this NAT Pool have
been reached. NATPool subsystem will try to replace the oldest
lingering state.
been reached. NATPool subsystem will try to replace the oldest
lingering state.
Gateway Action
replace_lingering
Recommended Action
Increase the MAXSTATES variable for this NATPool if more
concurrent states are wanted.
concurrent states are wanted.
Revision
1
Parameters
poolname
num_states
replacedip
num_states
replacedip
2.28.9. max_states_reached (ID: 05600010)
Default Severity
Log Message
Maximum amount of states <num_states> have been reached for
NATPool <poolname>. Replacing active state <replacedip>
NATPool <poolname>. Replacing active state <replacedip>
Explanation
The maximum configured number of states for this NAT Pool have
been reached. NATPool subsystem must replace an active state since
no lingering states exist.
been reached. NATPool subsystem must replace an active state since
no lingering states exist.
Gateway Action
replace_active
Recommended Action
Increase the MAXSTATES variable for this NATPool if more
concurrent states are wanted.
concurrent states are wanted.
2.28.7. proxyarp_failed (ID: 05600008)
Chapter 2. Log Message Reference
335