D-Link DAS-3224DC_revC Leaflet
18
Preparing for Installation
Tools and Equipment Required
The Table 3-3 lists the tools and equipment you need to install and remove the DAS3 Series system
components.
components.
Table 3-3
Installation Tools Lists
Check
Tools and Equipment
Hardware Components
DAS3 Series System
DC Power Module
RJ-45 to DB-9 Female adaptor
RJ-45 connector, straight-through 10Bast/100Base-T Ethernet, half/full-duplex
compliant with IEEE 802.3
compliant with IEEE 802.3
RJ-21
Telco
Cables
Software Components
AMS software package (Optional)
Tools
A 3/16 inch flat-head screwdriver
A Phillips-head screwdriver
Necessary equipment for ESD protection
Mounting screw – To mount the DAS3 Series system to the rack
Tie
wraps
Unpacking the DAS3 Series System
Each DAS3 Series system units is securely packaged in a shipping box.
To unpack the DAS3 Series units, complete the following steps:
Step 1
To unpack the DAS3 Series units, complete the following steps:
Step 1
Inspect the packing containers.
If any damage or other signs of mishandling are evident, inform both the local
freight carrier before unpacking. Your freight carrier can provide you with the
procedures necessary to file a claim for damages.
Step 2
Carefully open the box.
Step 3
Remove all packing material.
Step 4
Remove the unit form the box.
Step 5
Open the accessory kits and boxes that contain the cables, documentation, and
management software. Do not use a knife to open these boxes.
DAS3 Series IP-DSLAM
System Installation Guide