Nikon R1C1 User Manual

22

8 Using Cords

The SU-800 is connected to the SB-R200 
using cords when mounted on cameras 
not compatible with CLS. This indicator 
blinks if the SB-R200 is not correctly 
connected.

9 Flash Output Level Compensation 

Value (Groups A, B)
Indicates the flash output level 
compensation for groups A and B in the 
TTL mode.

0 Manual Mode

The flash always fires at a specified 
output in combination with the aperture 
and light output level (guide number).

Indicate that these items can be adjusted or 
changed. Stop after blinking six times unless an 
adjustment is made.

• Icons blinking also indicate warning and errors.
• When the [ON/OFF] + [MODE] buttons are simultaneously pressed (two-button reset) for 

approx. 2 sec., the display blinks three times (p. 19). 

t Using the SU-800 in low light

Press any button on the SU-800 to turn the illuminator on (when the SU-800’s 
power is on), and it will remain lit for about 16 seconds.

• The SU-800’s control button illuminator comes on when the camera’s LCD panel 

illuminator is turned on. 

• The control button illuminator goes out when the shutter is released.

t Characteristics of the LCD panel

• Due to the directional characteristics of LCDs, the LCD display is difficult to read when 

viewed from above. However, the display can be seen clearly from a somewhat lower 
angle.

• The LCD display becomes darker at high temperatures (approx. 60°C/140°F), but returns 

to normal at normal temperatures (20°C/68°F).

• The LCD’s response time slows down at low temperatures (approx. 5°C/41°F and below), 

but returns to normal at normal temperatures (20°C/68°F).