Canon imagePROGRAF iPF770 Manual

Once paper feeding starts, you will need to do the following, based on the ManageRemainRoll setting and the
barcode printed on rolls. 

Barcodes

Printer Operation After the Paper is Fed

Printed

A menu for selection of the type of paper is automatically shown on the Display Screen.
Press ▲ or ▼ to select the type of paper, and then press the OK button.

Not printed

Printed

The type and amount of paper left is automatically detected based on the barcode printed on the roll.
There is no need to specify the type and length of the paper.

Not printed A menu for selection of the paper type and length is automatically shown on the Display Screen.

Press ▲ or ▼ to select the type and length of paper loaded, and then press the OK button.

Note

For details on types of paper to select, see the Paper Reference Guide. 

 

Holding it at the positions indicated, close the Roll Cover.

Note

Cut the edge of the roll after the paper is advanced if it is soiled or if there are cuts from scissors or the blade
after removing creased edges. 

Follow these steps to change the type of paper specified on the printer after you have loaded paper.
If you will continue using this type of paper later, selecting Keep Paper Type > On will save the time and effort of con-
figuring the media type setting when you load the paper again. The current media type settings before you select On
will be automatically selected at that time. 

Important

For best printing results, the printer fine-tunes the print head height and the feed amount for each type of paper. Be
sure to select the type of paper to use correctly before printing.

Because the printer fine-tunes the feed amount for each type of paper, the margins and the size of printed images
may vary depending on the type of paper used. If margins and the size of images are not as you expected, adjust the
paper feed amount.

Rolls and sheets have different printing areas, and sheets having a larger bottom margin than rolls.

Changing the Type of Paper

Note

When you load a roll, a menu for selection of the type of paper is shown on the Display Screen. Select the type of
paper, and then press the OK button.
If no barcode has been printed on the roll and you have set ManageRemainRoll to On, specify the roll length after the
type of paper. 

 

iPF770

                                                                                                                                                                                           

Changing the Type of Paper

                                                                                                                                                                                                                             

Handling and Use of Paper

Handling rolls

359