Canon Océ VarioPrint 6000+ Series Manual

[Job by job]

You want to start the jobs one by one. Each time a job has been prin-
ted, the machine goes on hold. Always touch [Resume] in the dash-
board to start the next job.

[Check and print]

You want to check the quality and layout of each first set of a job be-
fore the remaining sets will be printed.

[Manual planning]

The jobs are sent to the machine in a random order. You can manually
define the most productive order in which the machine will print the
jobs.

[Unattended]

You want to continue printing while you are absent, for example after
working hours. Then the machine will print the scheduled jobs, provi-
ded that all the required media, supplies and output locations are avail-
able.

The following table gives an overview of the default [Receive] and [Print] settings of each
workflow profile.

The [Receive] and [Print] settings

[Standard]

[Scheduled jobs]

[Off]

[As in job]

[Job by job]

[As in job]

[On]

[As in job]

[Check and print]

[Scheduled jobs]

[Off]

[On]

[Manual planning]

[Waiting jobs]

[Off]

[As in job]

[Unattended]

[As in job]

[Off]

[Off]

The following table gives an overview of the default [Output] settings of each workflow profile.

The [Output] settings

[Standard]

[After each job]

[Sets (as in job)]

[On]

[Job by job]

[After each job]

[Sets (as in job)]

[On]

[Check and print]

[After each job]

[Sets (as in job)]

[On]

[Manual planning]

[After each job]

[Sets (as in job)]

[On]

[Unattended]

[When tray is full]

[Banners]

[Off]

NOTE

The setting [Link output locations] is only visible when 2 or more equally configured stackers are

available. For example, you cannot link the stackers when 1 stacker is configured for face-up

media, while the other is configured for face-down media. Furthermore, it is not possible to link

a stacker to a finisher.