Canon Océ VarioPrint 6000+ Series Manual
Values and effects of the settings
The following table describes the effects of the various values of the settings.
Values and effects of the settings
Setting
Values
Effect
[Destination of
print job]
print job]
[Scheduled jobs]
The jobs are immediately sent to the list of [Scheduled
jobs]. The machine will print the jobs in the ripped order.
You can do the following to rearrange the order in which
the jobs will be printed.
• Move jobs to the list of [Waiting jobs] or
• Use [To top] to move a job to the top of the list of
jobs]. The machine will print the jobs in the ripped order.
You can do the following to rearrange the order in which
the jobs will be printed.
• Move jobs to the list of [Waiting jobs] or
• Use [To top] to move a job to the top of the list of
[Scheduled jobs] (
).
[Waiting jobs]
You can manually define the order in which the jobs will
be printed.
be printed.
[As in job]
The submitted jobs go to the destination that is indica-
ted in the job ticket.
ted in the job ticket.
[Check first set]
[On]
The machine goes on hold after the first set of a job is
printed. You can check the quality and layout of the first
set before the machine prints the remaining sets.
printed. You can check the quality and layout of the first
set before the machine prints the remaining sets.
[Off]
The machine will print the whole job without stopping
after the first set.
after the first set.
[As in job]
The machine will print the jobs as indicated in the job
ticket.
ticket.
[Confirm start of
job]
job]
[On]
The machine always stops before the next scheduled
job. You must press the Release key to start each job.
job. You must press the Release key to start each job.
[Off]
The machine prints the scheduled jobs one after the oth-
er. The machine does not stop before the next scheduled
job, unless there is a reason to stop. For example when
a media is not available.
er. The machine does not stop before the next scheduled
job, unless there is a reason to stop. For example when
a media is not available.
[On conflict]
The machine stops before a job when one or more set-
tings are overruled by the controller.
tings are overruled by the controller.
[Next output tray] [After each job]
Each job is sent to the next available output tray. In this
context, the second stack of the stacker is also defined
as an output tray.
context, the second stack of the stacker is also defined
as an output tray.
[When tray is full] All the jobs are stacked until an output tray is full. When
an output tray is full, the next jobs are sent to the next
output tray.
output tray.
4
Work with the workflow profiles
40
Chapter 5 - Adapt printer settings to your needs