Canon Océ VarioPrint 6000+ Series Manual
C
B
A
[49] Trimmer infeed conveyor viewed from above 2
A
Trimmer infeed conveyor
B
Trimmings removal fingers
C
Former clamp mechanism
Step
Action
Information
1
Lift the Booklet maker main deck.
See
2
Remove the trim bin.
3
Clean the four visible trimmings-re-
moval fingers with an alcohol wipe.
moval fingers with an alcohol wipe.
The procedure can be seen from the top
of the machine.
Access to the parts is through the former-
clamp mechanism (see illustration 'Trim-
mer infeed conveyor viewed from above
1').
Wear protective gloves when you use the
alcohol wipe.
of the machine.
Access to the parts is through the former-
clamp mechanism (see illustration 'Trim-
mer infeed conveyor viewed from above
1').
Wear protective gloves when you use the
alcohol wipe.
4
Rotate the conveyor shaft by half a
turn.
turn.
1. Hold the shaft and push to the right,
against spring pressure to disengage the
shaft from the drive pin.
against spring pressure to disengage the
shaft from the drive pin.
1
2
3
2. Rotate the shaft by half a turn.
3. Align the shaft with the drive pin and
release.
3. Align the shaft with the drive pin and
release.
5
Clean the four visible trimmings-re-
moval fingers with an alcohol wipe.
moval fingers with an alcohol wipe.
Wear protective gloves when you use the
alcohol wipe.
alcohol wipe.
6
Fit the trim bin.
7
Close the Booklet maker.
Clean the Trimmings Removal Fingers
116
Chapter 7 - Maintenance