Olympus c-211 zoom Introduction Manual

The camera is turned OFF.

➔

Turn the mode dial to a position other than OFF. (p.25)

Batteries are incorrectly installed.

➔

Remove the batteries and reload them correctly. (p.28)

No batteries, or batteries are dead.

➔

Load fresh batteries. (p.28)

Environment is very cold, causing reduced battery performance.

➔

Keep the batteries warm (place them in your pocket, etc.), then load them just
before use. (p.17)

The camera is in sleep mode (power-save mode).

➔

Turn the mode dial to OFF, then turn it back to the appropriate mode. (p.42)

The camera is connected to a computer.

➔

Camera functions are automatically disabled while the camera is connected to a
computer. (p.185)

Batteries were left in the camera during a long period of non-use.

➔

Remove the batteries if you do not plan to use the camera for a long period of time.

The camera is still writing the previous shot to memory, or the flash is still charging.

➔

Take your finger off the shutter release button and wait until the green lamp’s blink
rate slows down. Then try again. (pp.50, 85)

There’s a problem with the card.

➔

Refer to “Error Messages” on page 200 for more information.

The card is full.

➔

Change to a different card (p.32), or delete some of the images on the existing card
to free up some space (p.74). To recover even more space, transfer all images from
the card to your computer and then use the “Erase Card” function (p.151).

Batteries are low or are completely dead.

➔

Replace the batteries. (If the green lamp is blinking, wait for the lamp to go off
before making the replacement.)