Netgear M4300-28G (GSM4328S) - Stackable Managed Switch with 24x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 Software Guide

ARP Entries.................................... 1536

IPv4 Unicast Routes............................ 512

IPv6 NDP Entries............................... 512

IPv6 Unicast Routes............................ 256

ECMP Next Hops................................. 4

IPv4 Multicast Routes.......................... 96

IPv6 Multicast Routes.......................... 32

Maximum VLAN Entries........................... 4093

On the next reload, the template will be the 'ipv4 data center plus generic' template.

This section describes the commands you use to configure Green Ethernet modes on the 
system. The purpose of the Green Ethernet features is to save power. The switch supports 
the following Green Ethernet modes:

Energy-detect mode

Energy-efficient Ethernet (EEE) mode

Only 1G copper ports support energy-detect mode.

Use this command to enable energy-detect mode on an interface or on a range of interfaces. 
With this mode enabled, when the port link is down, the port automatically powers down for 
short period of time and then wakes up to check link pulses. In energy-detect mode, the port 
can perform auto-negotiation and consume less power when no link partner is present.

Use this command to disable energy-detect mode on the interface(s).

Default

disabled

Format

green-mode energy-detect

Mode

Interface Config

Format

no green-mode energy-detect

Mode

Interface Config