Netgear M4300-28G (GSM4328S) - Stackable Managed Switch with 24x1G and 4x10G including 2x10GBASE-T and 2xSFP+ Layer 3 Software Guide
Utility Commands
327
M4200 and M4300 Series ProSAFE Managed Switches
green-mode eee
Use this command to enable EEE low-power idle mode on an interface or on a range of
interfaces. The EEE mode enables both send and receive sides of the link to disable some
functionality for power saving when lightly loaded. The transition to EEE low-power mode
does not change the port link status. Frames in transit are not dropped or corrupted in
transition to and from this mode.
interfaces. The EEE mode enables both send and receive sides of the link to disable some
functionality for power saving when lightly loaded. The transition to EEE low-power mode
does not change the port link status. Frames in transit are not dropped or corrupted in
transition to and from this mode.
no green-mode eee
Use this command to disable EEE mode on the interface(s).
green-mode eee tx-idle-time
Use this command to configure the EEE mode transmit idle time for an interface or range of
interfaces. The idle time is in microseconds (0–4294977295). The transmit idle time is the
amount of time the port waits before moving to the MAC TX transitions to the LPI state.
interfaces. The idle time is in microseconds (0–4294977295). The transmit idle time is the
amount of time the port waits before moving to the MAC TX transitions to the LPI state.
no green-mode eee tx-idle-time
Use this command to return the EEE idle time to the default value.
green-mode eee tx-wake-time
Use this command to configure the EEE mode transmit wake time for an interface or range of
interfaces. The wake time is in microseconds (0–65535). The transmit wake time is the
amount of time the switch must wait to go back to the ACTIVE state from the LPI state when
it receives a packet for transmission.
interfaces. The wake time is in microseconds (0–65535). The transmit wake time is the
amount of time the switch must wait to go back to the ACTIVE state from the LPI state when
it receives a packet for transmission.
Default
disabled
Format
green-mode eee
Mode
Interface Config
Format
no green-mode eee
Mode
Interface Config
Default
0
Format
green-mode eee tx-idle-time microseconds
Mode
Interface Config
Format
no green-mode eee tx-idle-time
Mode
Interface Config