Netgear WC7500 - ProSAFE® Wireless Controller User Manual

To change the properties for an antenna, do the following:

a. Double-click the antenna.

A pop-up menu displays.

b.  From the pop-menu, select Edit Properties.

The Edit Antenna pop-up window opens. This window is identical to the Add Antenna 
pop-up window.

c.  Change the properties.

For information about the properties, see the previous table.

d.  Click the Confirm button.

Your settings are saved and the pop-up window closes.

To remove an existing antenna from the floor map, do the following:

a. Click the antenna to select it.

b.  Click the Delete link.

To add another antenna to the floor map, change the properties for another antenna, move 
another antenna on the floor map, remove another antenna from the floor map, or perform a 
combinations of these tasks, repeat 

To turn the heat map on or off, on the right, click the HeatMap 

 icon.

If you turn on the heat map, the heat map is generated and displays. Use the color 
information on the right as guidance for WiFi coverage.

Adding or removing antennas changes the heat map.

To switch the heat map to the 2.4 GHz or 5 GHz band (for antennas that support dual 
bands), on the right, click the Band 

 icon.

The Band icon displays 2.4G if the heat map for the 2.4 GHz band is shown. The Band 
icon displays 5G if the heat map for the 5 GHz band is shown.

To show the map with or without grid, on the right side, click the Grid 

 icon.

To show the antennas by model or without a label, on the right side, click the Label 

 icon 

and select your preference.

By default, the antenna name is shown. The IP address and channel do not apply to an 
antenna.

To save the floor map with its new configuration, click the Save  

icon.

The settings are saved.