Netgear WNDAP350 – ProSAFE Dual Band Wireless-N Access Point User Manual
Basic Installation and Configuration
22
ProSAFE Dual Band Wireless N Access Point WNDAP350
Configuring Wireless Access
To configure your wireless settings for 11b/bg/ng and 11a/na:
1.
From the main menu under Configuration, select Wireless. The Wireless Settings
screen displays, as shown in
screen displays, as shown in
Figure 9, Basic Wireless Settings for 802.11b/bg/ng
.
2.
3.
Click Apply to save your settings.
Figure 9. Basic Wireless Settings for 802.11b/bg/ng
When you have completed the setup steps, you can deploy the WNDAP350 in your network.
If needed, you can now reconfigure the computer you used in step 1 (from the Static IP) back
to its original TCP/IP settings.
If needed, you can now reconfigure the computer you used in step 1 (from the Static IP) back
to its original TCP/IP settings.
Deploying the WNDAP350 Wireless Access Point
To deploy the WNDAP350 wireless access point:
1.
Disconnect the WNDAP350 and position it where it will be deployed. The best location
is elevated, such as wall mounted or on the top of a cubicle, at the center of your
wireless coverage area, and within line of sight of all the mobile devices.
is elevated, such as wall mounted or on the top of a cubicle, at the center of your
wireless coverage area, and within line of sight of all the mobile devices.
2.
Lift the antenna on either side so that they are vertical.
Note:
Refer to the antenna positioning and wireless mode configuration
information in
information in
3.
Connect an Ethernet cable from your WNDAP350 wireless access point to a LAN port on
your router, switch, or hub.
your router, switch, or hub.