Netgear M7300-24XF (XSM7224S) - ProSAFE 24-port, 10 Gigabit Stackable L2+ Managed Switch Leaflet
Switching Commands
110
ProSafe Managed Switch
storm-control multicast rate (Global)
Use this command to configure the multicast storm recovery threshold for all interfaces in
packets per second. If the mode is enabled, multicast storm recovery is active, and if the rate
of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold,
the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured
threshold.
packets per second. If the mode is enabled, multicast storm recovery is active, and if the rate
of L2 broadcast traffic ingressing on an interface increases beyond the configured threshold,
the traffic is dropped. Therefore, the rate of multicast traffic is limited to the configured
threshold.
Default
Format
storm-control multicast rate <0-14880000>
Mode
no storm-control broadcast rate
This command sets the broadcast storm recovery threshold to the default value for all
interfaces and disables broadcast storm recovery.
interfaces and disables broadcast storm recovery.
Format
no storm-control broadcast rate
Mode
storm-control unicast
This command enables unicast storm recovery mode for an interface. If the mode is enabled,
unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup
failure) traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured
threshold.
unicast storm recovery is active, and if the rate of unknown L2 unicast (destination lookup
failure) traffic ingressing on an interface increases beyond the configured threshold, the traffic
will be dropped. Therefore, the rate of unknown unicast traffic will be limited to the configured
threshold.
Default
Format
storm-control unicast
Mode
no storm-control unicast
This command disables unicast storm recovery mode for an interface.
Format
no storm-control unicast
Mode
storm-control unicast level
This command configures the unicast storm recovery threshold for an interface as a
percentage of link speed, and enables unicast storm recovery. If the mode is enabled, unicast
storm recovery is active, and if the rate of unknown L2 unicast (destination lookup failure)
traffic ingressing on an interface increases beyond the configured threshold, the traffic will be
percentage of link speed, and enables unicast storm recovery. If the mode is enabled, unicast
storm recovery is active, and if the rate of unknown L2 unicast (destination lookup failure)
traffic ingressing on an interface increases beyond the configured threshold, the traffic will be
0
Global Config
Global Config
disabled
Interface Config
Interface Config