Netgear M4100-50-POE (FSM7250Pv1h1) - 48‐port FE + 2 GE Combo L2 Managed PoE Switch Software Guide
Routing Commands
229
M4100 Series ProSAFE
Managed
Switches
ip proxy-arp
This command enables proxy ARP on a router interface. Without proxy ARP, a device only
responds to an ARP request if the target IP address is an address configured on the interface
where the ARP request arrived. With proxy ARP, the device might also respond if the target
IP address is reachable. The device responds only if all next hops in its route to the
destination are through interfaces other than the interface that received the ARP request.
responds to an ARP request if the target IP address is an address configured on the interface
where the ARP request arrived. With proxy ARP, the device might also respond if the target
IP address is reachable. The device responds only if all next hops in its route to the
destination are through interfaces other than the interface that received the ARP request.
no ip proxy-arp
This command disables proxy ARP on a router interface.
arp cachesize
This command configures the ARP cache size. The ARP cache size value is a
platform-specific integer value. The default size also varies depending on the platform.
platform-specific integer value. The default size also varies depending on the platform.
no arp cachesize
This command configures the default ARP cache size.
arp dynamicrenew
This command enables the ARP component to automatically renew dynamic ARP entries
when they age out.
when they age out.
Default
enabled
Format
ip proxy-arp
Mode
Interface Config
Format
no ip proxy-arp
Mode
Interface Config
Format
arp cachesize <platform specific integer value>
Mode
Global Config
Format
no arp cachesize
Mode
Global Config
Default
enabled
Format
arp dynamicrenew
Mode
Privileged EXEC