Netgear M4100-50-POE (FSM7250Pv1h1) - 48‐port FE + 2 GE Combo L2 Managed PoE Switch Software Guide
Routing Commands
231
M4100 Series ProSAFE
Managed
Switches
no arp retries
This command configures the default ARP count of maximum request for retries.
arp timeout
This command configures the ARP entry ageout time.
The value for <seconds> is a valid positive integer, which represents the IP ARP entry
ageout time in seconds. The range for <seconds> is between 15-21600 seconds.
ageout time in seconds. The range for <seconds> is between 15-21600 seconds.
no arp timeout
This command configures the default ARP entry ageout time.
clear arp-cache
This command causes all ARP entries of type dynamic to be removed from the ARP cache. If
the gateway keyword is specified, the dynamic entries of type gateway are purged as well.
the gateway keyword is specified, the dynamic entries of type gateway are purged as well.
clear arp-switch
Use this command to clear the contents of the switch’s Address Resolution Protocol (ARP)
table that contains entries learned through the Management port. To observe whether this
command is successful, ping from the remote system to the DUT. Issue the show arp
switch
table that contains entries learned through the Management port. To observe whether this
command is successful, ping from the remote system to the DUT. Issue the show arp
switch
command to see the ARP entries. Then issue the clear arp-switch command
and check the show arp switch entries. There will be no more arp entries.
Format
no arp retries
Mode
Global Config
Default
1200
Format
arp timeout <seconds>
Mode
Global Config
Format
no arp timeout
Mode
Global Config
Format
clear arp-cache [gateway]
Mode
Privileged EXEC
Format
clear arp-switch
Mode
Privileged EXEC