Netgear GS728TPS(B) – ProSAFE 24-Port Gigabit Stackable Smart Switch with PoE and 4 SFP uplinks Software Guide

is not issued if the ACL rule hit count is zero for the current interval. This field is only 
supported for a Deny action. 

Mirror Interface: Specifies the specific egress interface where the matching traffic 

stream is copied in addition to being forwarded normally by the device. This field 
cannot be set if a Redirect Interface is already configured for the ACL rule. This field 
is visible for a Permit action. Mirrored interfaces do not need to be part of the traffic 
VLAN.

Redirect Interface: Specifies the specific egress interface where the matching traffic 

stream is forced, bypassing any forwarding decision normally performed by the 
device. This field cannot be set if a Mirror Interface is already configured for the ACL 
rule. This field is visible for a Permit action. Redirected interfaces should be part of 
the traffic VLAN.

Match Every: Select true or false from the pull down menu. True signifies that all 

packets will match the selected IPv6 ACL and Rule and will be either permitted or 
denied. In this case, since all packets match the rule, the option of configuring other 
match criteria will not be offered. To configure specific match criteria for the rule, 
remove the rule and recreate it, or reconfigure Match Every to False for the other 
match criteria to be visible.

Protocol: There are two ways to configure IPv6 protocol:

Specify an integer ranging from 0 to 255 after selecting protocol keyword “other”. 

This number represents the IPv6 protocol.

Select name of a protocol from the existing list of IPv6, ICMPv6, TCP, and UDP.

Source Prefix/Prefix Length: Specify IPv6 Prefix combined with IPv6 Prefix length of 

the network or host from which the packet is being sent. Prefix length can be in the 
range (0 to 128).

Source L4 Port: Specify a packet's source layer 4 port as a match condition for the 

selected IPv6 ACL rule. Source port information is optional. Source port information 
can be specified in two ways:

Select keyword “other” from the drop-down menu and specify the number of the 

port in the range from 0 to 65535.

Select one of the keyword from the list: DOMAIN, ECHO, FTP, FTPDATA, HTTP, 
SMTP, SNMP, TELNET, TFTP, and WWW. Each of these values translates into its 
equivalent port number, which is used as both the start and end of the port range.

Destination Prefix/Prefix Length: Enter up to 128-bit prefix combined with prefix 

length to be compared to a packet's destination IP Address as a match criteria for the 
selected IPv6 ACL rule. Prefix length can be in the range (0 to 128).

Destination L4 Port: Specify a packet's destination layer 4 port as a match condition 
for the selected IPv6 ACL rule. Destination port information is optional. Destination 
port information can be specified in two ways:

Select keyword “other” from the drop-down menu and specify the number of the 

port in the range from 0 to 65535.

Select one of the keyword from the list: DOMAIN, ECHO, FTP, FTPDATA, HTTP, 
SMTP, SNMP, TELNET, TFTP, and WWW. Each of these values translates into its 
equivalent port number, which is used as both the start and end of the port range.