Netgear M4300-52G-PoE+ (GSM4352PA) - 48x1G PoE+ Stackable Managed Switch with 2x10GBASE-T and 2xSFP+ (550W PSU) Software Guide

This command creates a private group with a name or an identifier. The name string can be 
up to 24 bytes of non-blank characters. A total number of 192 of private groups is supported. 
Therefore, the group identifier can be from 1 to 192.

The private-group-id parameter is optional. If you do not specify a group identifier, the 
identifier is assigned automatically.

The optional mode for the group can be either isolated or community. If the private group is in 
isolated mode, the member port in the group cannot forward its egress traffic to any other 
members in the same group. By default, the mode for the private group is community mode, 
allowing each member port to forward traffic to other members in the same group, but not to 
members in other groups.

This command removes a private group.

This command displays information about a private group. If you do not specify a group 
name, group identifier, or port, the command displays information about all private groups.

Format

private-group name privategroup-name [private-group-id] [mode {community | 

isolated}]

Mode

Global Config

Format

no private-group name privategroup-name

Mode

Global Config

Format

show private-group [private-group-name | private-group-id | port 

unit/slot/port]

Mode

Privileged EXEC

Interface

A valid slot and port number separated by forward slashes.

Port VLANID

The VLAN ID that is associated with the port.

Private Group ID The identifier of the private group (from 1 to 192).

Private Group 
Name

The name of the private group. The name string can be up to 24 bytes of non-blank characters.

Private Group 
Mode

The mode of the private group. The mode can be either isolated or community.