Netgear M4300-52G-PoE+ (GSM4352PA) - 48x1G PoE+ Stackable Managed Switch with 2x10GBASE-T and 2xSFP+ (550W PSU) Software Guide

This command displays the OSPF stub table. The information below will only be displayed if 
OSPF is initialized on the switch.

This command displays the OSPF Virtual Interface information for a specific area and 
neighbor. The area-id parameter identifies the area and the neighbor parameter 
identifies the neighbor’s Router ID.

Format

show ipv6 ospf stub table

Modes

Privileged EXEC

User EXEC

Area ID

A 32-bit identifier for the created stub area.

Type of Service

Type of service associated with the stub metric. For this release, Normal TOS is the only 
supported type.

Metric Val

The metric value is applied based on the TOS. It defaults to the least metric of the type of 
service among the interfaces to other areas. The OSPF cost for a route is a function of the 
metric value.

Import Summary LSA

Controls the import of summary LSAs into stub areas.

Format

show ipv6 ospf virtual-link area-id neighbor

Modes

Privileged EXEC

User EXEC

Area ID

The area id of the requested OSPF area.

Neighbor Router ID

The input neighbor Router ID.

Hello Interval

The configured hello interval for the OSPF virtual interface.

Dead Interval

The configured dead interval for the OSPF virtual interface.

Interface Transmit Delay

The configured transmit delay for the OSPF virtual interface.

Retransmit Interval

The configured retransmit interval for the OSPF virtual interface.

Authentication Type

The type of authentication the interface performs on LSAs it receives.

State

The OSPF Interface States are: down, loopback, waiting, point-to-point, designated router, 
and backup designated router. This is the state of the OSPF interface.

Neighbor State

The neighbor state.