Netgear FVS318v3 – Cable/DSL ProSafe VPN Firewall with 8-Port Switch Reference Manual
Sample VPN Configurations with FVS318v3
C-1
v5.0, January 2012
Appendix C
Sample VPN Configurations with FVS318v3
This is a case study on how to configure a secure IPSec VPN tunnel on a NETGEAR FVS318v3.
This case study follows the VPN Consortium interoperability profile guidelines (found at
This case study follows the VPN Consortium interoperability profile guidelines (found at
http://www.vpnc.org/InteropProfiles/Interop-01.html
).
This study covers the following situations:
•
FVS318v3 to FVS318v3 (see
).
•
FVS318v3 to FVS318v2 (see
•
•
FVS318v3 to VPN Client (see
Case Study Overview
The procedure for configuring a VPN tunnel between two gateway endpoints is as follows:
1. Gather the network information
2. Configure gateway A
3. Configure gateway B
4. Activate the VPN tunnel
Gathering the Network Information
The configuration in this document follows the addressing and configuration mechanics defined
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
by the VPN Consortium. Gather all the necessary information before you begin the configuration
process. Verify whether the firmware is up to date, all of the addresses that will be necessary, and
all of the parameters that need to be set on both sides. Check that there are no firewall restrictions.
Note: Product updates are available on the NETGEAR, Inc. Web site at
.