Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch User Manual
104
|
Chapter 2. Configuring System Information
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
LLDP Global Configuration
Use the LLDP Global Configuration page to specify LLDP parameters that are applied to the
switch.
switch.
To display this page, click System
LLDP
LLDP
Global Configuration. A screen similar
to the following displays.
To configure global LLDP settings:
1.
Use Transmit Interval to specify the interval in seconds to transmit LLDP frames. The
range is from 5 to 32768 secs. Default value is 30 seconds.
range is from 5 to 32768 secs. Default value is 30 seconds.
2.
Use Transmit Hold Multiplier to specify the multiplier on Transmit Interval to assign TTL.
The range is from 2 to 10 secs. Default value is 4.
The range is from 2 to 10 secs. Default value is 4.
3.
Use Re-Initialization Delay to specify the delay before re-initialization. The range is from 1
to 10 secs. Default value is 2 seconds.
to 10 secs. Default value is 2 seconds.
4.
Use Notification Interval to specify the interval in seconds for transmission of notifications.
The range is from 5 to 3600 secs. Default value is 5 seconds.
The range is from 5 to 3600 secs. Default value is 5 seconds.
5.
Click CANCEL to cancel the configuration on the screen. Resets the data on the screen to
the latest value of the switch.
the latest value of the switch.
6.
Click APPLY to send the updated configuration to the switch and cause the changes to take
effect on the switch but these changes will not be retained across a power cycle unless a
save is performed.
effect on the switch but these changes will not be retained across a power cycle unless a
save is performed.