Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch User Manual

To configure Port Mirroring:

Select the check box next to a port to configure it as a source port. 

Mode - Specifies the Mode for mirroring. By default Mode is disabled.

Use Source Port to specify the configured port(s) as mirrored port(s). Traffic of the 
configured port(s) is sent to the probe port.

In the Destination Port field, specify the port to which port traffic is be copied. Use the 
unit/slot/port format to specify the port. You can configure only one destination port on the 
system. Acts as a probe port and will receive all the traffic from configured mirrored port(s). 
Default value is blank.

From the Session Mode menu, select the mode for port mirroring on the selected port:

Enable - Multiple Port Mirroring is active on the selected port.

Disable - Port mirroring is not active on the selected port, but the mirroring 

information is retained.

Direction - Specifies the direction of the Traffic to be mirrored from the configured mirrored 
port(s). Default value is Tx and Rx.

Click Apply to apply the settings to the system. If the port is configured as a source port, the 
Mirroring Port field value is Mirrored.

To delete a mirrored port, select the check box next to the mirrored port, and then click 
Delete.

Click Cancel to cancel the configuration on the screen and reset the data on the screen to 
the latest value of the switch.

Mirroring Port

Indicates the port to be in a mirrored state.

sFlow

From the sFlow link under the Monitoring tab, you can access the following pages:

Basic

From the Basic link, you can access the following pages:

To display the sFlow Agent page, click Monitoring









 sFlow Agent.