Netgear FS752TP – 48 10/100 Mbps RJ45 ports and 2 gigabit combo (copper/SFP) ports and 2 gigabit RJ45 ports Software Guide

Unauthorized: Denies the selected interface system access by moving the 

interface into unauthorized state. The switch cannot provide authentication 
services to the client through the interface.

. This field allows the user to configure the Guest VLAN ID on the 

interface. The valid range is 0–4093.The default value is 0. Enter 0 to reset the Guest 
VLAN ID on the interface.

. This input field allows the user to enter the Guest VLAN period 

for the selected port. The Guest VLAN period is the value, in seconds, of the timer 
used by the Guest VLAN Authentication. The Guest VLAN timeout must be a value in 
the range of 1–300. The default value is 90.

. Use this field to enable or disable reauthentication of the 

supplicant for the specified port. Select Enable and Disable. If the value is Enable, 
reauthentication will occur. Otherwise, reauthentication will not be allowed. The 
default value is Disable. Changing the selection will not change the configuration until 
the Apply button is pressed.

. Indicates the time span in which the selected port is 

reauthenticated. The field value is in seconds. The range is 1–65535, and the field 
default is 3600 seconds.

. Defines the amount of time that the switch remains in the quiet state 

following a failed authentication exchange. The possible field range is 0–65535. The 
field value is in seconds. The field default is 60 seconds.

. This input field allows you to configure the transmit period for the 

selected port. The transmit period is the value, in seconds, of the timer used by the 
authenticator state machine on the specified port to determine when to send an 
EAPOL EAP Request/Identify frame to the supplicant. The transmit period must be a 
number in the range of 1–65535. The default value is 30. Changing the value will not 
change the configuration until you click the Apply button.

. This input field allows you to enter the maximum requests for 

the selected port. The maximum requests value is the maximum number of times the 
authenticator state machine on this port will retransmit an EAPOL EAP 
Request/Identity before timing out the supplicant. The maximum requests value must 
be in the range of 1–10. The default value is 2. Changing the value will not change the 
configuration until you click the Apply button.

. Defines the amount of time that lapses before EAP requests 

are resent to the user. The field value is in seconds. The field default is 30 seconds.

. Defines the amount of time that lapses before the switch resends a 

request to the authentication server. The field value is in seconds. The range is 
1–65535, and the field default is 30 seconds.

. This displays the control direction for the specified port, which is 

always Both. The control direction dictates the degree to which protocol exchanges 
take place between Supplicant and Authenticator.The unauthorized controlled port 
exerts control over communication in both directions (disabling both incoming and 
outgoing frames). This field is not configurable.