Xerox XEScan Solution Installation Guide

5

1.  Insert the CD-ROM into the PC CD-ROM Drive. The installation program automatically runs if

Autorun is enabled. If it is not enabled, click the Start button. Then click Run… and Browse to
the CD drive.

2.  Select the SETUP.EXE file and click Open. Then click OK.

3.  Click on the pull-down menu and select the desired language. Click OK.

4.  The welcome screen displays. Click Next.

5.  The license screen is displayed. Read it thoroughly. If you agree to the terms, click Yes. If you

do not agree, click No and the installation terminates.

6.  The application displays a screen offering the opportunity to change the folder where the

XEScan application is installed. Choose the default by clicking Next.

7.  The application displays a screen requesting the selection of the type of installation. Select

Typical.  Then click Next.

8.  The Completion Status Bar screen appears and displays the status of the installation.

9.  Follow the instructions on the screen to install the Hardlock driver software.

10.  After the driver software is installed, a screen appears and displays that the Hardlock driver

installation is finished.  Select the Finish button to confirm.

11.  The Diagnostics installation begins automatically. The Welcome Screen displays. Click Next.

12.  Fill in the User Name and Organization fields. Leave the radio button checked for Install this

application for: Anyone who uses this computer (all users). Click on Next.

13. Leave the Setup Type selected as Complete. Click Next.

14.  Confirm that you wish to install the Diagnostics by clicking Install.

15.  The Completion Status Bar screen appears and displays the status of the installation.

16.  A screen displays confirming the installation of the Diagnostics. Click on Finish.

17.  The Completion screen displays. Click on Finish.

18.  Install the Unibrain drivers (UbCore) by clicking on Start > Programs > XES Programs >

Install Unibrain Fireboard Drivers. Choose the default options by clicking Next. Click on
Finish.

.  Click on “Diagnostic Upgrade – Service

Update the Scanner Firmware if you are currently below version 2.2.4.  You can verify this by opening
the Diagnostic Utility and clicking the Scanner tab under System Description.  The scanner firmware
version is the 2

nd

 line item in the Scanner Tab.

This procedure updates the scanner firmware. New firmware is occasionally posted on the XES
website (

http://www.XES.com

) to correct problems and improve performance of the scanner.

1.  Power on the scanner and observe the LED display (on the back of the scanner) for the

completion of the POST tests. After three minutes, a “P” will be displayed on the LED.

2.  Power on the PC and observe the system for proper start up.

Note: Verify that the LED on the rear of the scanner has a dot lit next to the displayed 'P'  after
Windows starts. The dot means the PC and scanner are communicating.