Xerox Xerox 8830 Digital Solution with AccXES Controller serial number CNG Leaflet

Note: You must have Internet access to replace Feature Keys.

1.  Using your Internet browser, access

, then click the appropriate

language button.

2.  Click on “Replace all keys after software upgrade” and click “Continue.”

Note: Refer to Table 1 to determine which address and serial number is required.

3. Enter 

the:

•

 

Scanner HW Address, IOT HW (Hardware) Address, or Key Install Key
number from the Test Print or WebPMT, Printer Defaults.

•

 Click 

“Continue”.

4.  A “File Download” dialog box will appear, clicks Save.  A “Save As” window will

open. Choose the location (Save In:) to save the file, and change the file name
if you desire. Click Save to save the “replacement.plt” file to your hard drive
location or to the diskette that came in this kit. Close the “Download Complete”
window.

5.  Upload the “replacement.plt” to the Controller using the Web PMT.

•

 Open 

the 

WebPMT.

•

 

Navigate to PRINTER DEFAULTS > UTILITIES > Upload File.

•

 

Browse to where you saved the “replacement.plt” file in Step 4 and upload
the file.

Note: The AccXES Client Tools, Document Submit Tool can also be used
(Reference the AccXES Client Tools User Guide)). Send the key file(s) the same
as you would send a print job. The Controller will recognize the file extension and
load the key(s)

6.  After waiting 60 seconds, reboot your entire system to enable the feature key.

Wait for the system to complete the reboot and is ready to accept prints.

Note: If required, reference the XES Synergix 8825/8830/8850/8855/510dp/721p
Digital Solutions User Guide, Powering Off the Digital Solution or the Colorgrafx X2
User Guide, for reboot instructions.

7.  Print another Printer Configuration Test Print “Minimal” to verify that the

feature(s) is/are enabled.  (See Figure 1).

Check under the OPTIONAL CONTROLLER FEATURES section.  “Present”
should appear opposite each feature license that was installed.  The color
license is located under the SCANNER CONFIGURATION.